Name: TVS Engineering | DQ200 (Gen3 MQB) 2013+ | Software Package | Stage 2+ ECU - Stage 3 TCU
Brand: TVS Engineering
SKU: TVS-DQ200-GEN3-ECU2+-TCU3
Price: 786.96 GBP
Availability: InStock

TVS ECU / TCU Software Package | Stage 2+ ECU - Stage 2+ TCU – For VAG vehicles fitted with the DQ200 gearbox, 2013 - Present

This software is described as the maximum performance upgrade with a stock engine setup that is supported by performance hardware such as a cold air intake, DownPipe / Exhaust. Higher quality fuel grades are advised. While the TCU is increasing the torque limits to suit the extra power and torque from the ECU calibration, to ensure the increased power will not cause any additional wear on transmission parts due to the increased power output from the engine.

TVS ECU Stage 2+ highlights:

TVS TCU Stage 2+ highlights:

Custom TVS Stage 2+ ECU calibration, all TVS optional features included making your calibration completely customisable.
Data analysing and fine tuning.
Dyno run and dyno sheet.
Engine and Gearbox Diagnostics.
Improved temperature protection - enhanced engine cooling and oil temperature management.
Ability to remove vehicle speed limiters.
Motorsport rev limiter (hard cut) - As well as adjust the point of the limiter.
Diesel Particulate Filter (DPF) / Exhaust Gas Recirculation (EGR) / Lambda-O2 Delete (decat) - deactivation.
Exhaust Crackle / Over run / Decel.
Intake Swirl flaps delete.
Cylinder On Demand (COD) / Active Cylinder technology (ACT) / Start-Stop Removal.
Map sensor scaling.
Upgraded injector calibration.
Improved fuel economy.

More responsive and better drivability in D and S modes
Raised torque limits (400nm)
Faster shifting speeds
Unnecessary/harsh downshifts removed
Bump elimination during 1st - 2nd gear shift
Fix for bouncing RPM needle
Fully customisable

TVS ECU Stage 2+ software optimises the engine performance of the VAG platform vehicles. While the TVS TCU stage 2+ software includes the Drivability Upgrade and further optimises performance of the 6-speed DQ200 DSG gearbox for tuned vehicles with the following engines: 1.6 TDI, 1.9 TDI, 1.2 TSI 1.8 TSI, 1.6 FSI (2013 - Present).

While the DQ200 DSG system is known to be generally strong, reliable and easy to use, there are some known issues, which can hamper drivability, especially with tuned vehicles.

These include: lack of response (delay in shifting); harsh, unwanted kickdown and a less-than-smooth pull away from standstill. From the factory, Sport mode is too aggressive and high-revving for many situations, while in Drive, shifts may feel sluggish – both impacting on the drivability of the vehicle.

The TCU software removes unnecessary downshifts, allowing you to hold onto a gear for longer, but also increases the shifting speed, which provides a more responsive and enjoyable driving experience. With the clutch clamping force and torque limits both increased, the TVS DQ200 Stage 2+ software can handle up to 400Nm on stock clutches. While the ECU software allows the maximum performance to be extracted from a stock engine with minimal performance hardware added.

TVS Software must be installed at either PERON HQ or any of our UK Dealers premises. This software is not currently available as a home-flash service.